Welcome, Guest

1
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/how-to-car-repair-how-to-estimate-cost.html[/postlink] http://www.youtube.com/watch?v=7r_d4fMNQE8endofvid [starttext]nice tape measure... you building a house? [endtext]

How to: Car Repair : How to Estimate the Cost of Auto Body Repair

1
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/how-to-check-fuel-pump.html[/postlink] http://www.youtube.com/watch?v=Ih-ib8i1IIMendofvid [starttext]thanks for the tip on that, but i have compression and spark at the plugs, because the engine fires right up when i spray starting fluid. I did discover that the 'fuel pump/ecm' fuse was blown; i replaced the fuse, but no crank and car dies as soon as starting spray is gone...I have even replaced the ECM, after concluding that fuel injectors were not dispersing fuel...Is there a component between the ECM and the Injectors that may be hindering ground pulses? Thanks torau666. [endtext]

How to check the fuel pump

0
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/how-to-fix-blazer-fuel-pump.html[/postlink] http://www.youtube.com/watch?v=CuPYzywb7J4endofvid [starttext]Very informative, thanks so much. [endtext]

How To Fix A Blazer Fuel Pump

0
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/how-to-replace-electric-fuel-pump.html[/postlink] http://www.youtube.com/watch?v=1V-257Bn0sAendofvid [starttext] i took off the injector top & poured gas in the throttle body it ran then stopped when da gas was gone do u think the wires ran wrong inside the fuel pump or maybe the filter needs changing [endtext]

How to Replace An Electric Fuel Pump

0
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/maf-problem.html[/postlink] http://www.youtube.com/watch?v=GdWkqO-vuOQendofvid [starttext]i have the same problem it go normal when i unpluged it but when it is on it idle below 7000 to about 6500....did u try cleaning the MAF...i need help solving it to [endtext]

MAF problem

1
[postlink] http://how-to-auto-repair.blogspot.com/2011/08/auto-repair-maintenance-how-to-know-if.html[/postlink] http://www.youtube.com/watch?v=nNpwk3qtZokendofvid [starttext] One way to check to see if a mass air flow sensor has gone bad is by tapping on the engine when it's running to see if it stumbles. [endtext]

Auto Repair & Maintenance : How to Know if a Mass Air Flow Sensor Is Bad